Ok so I've got my '15 750. Really haven't worked on the engine other than oil changes as needed. Having said that, I was on the bike going to work (on the third anniversary of buying it no less..) when I lost all power on the interstate/highway.
Well I pull over and see what looks like a bolt sticking through the belt cover. My Heart sinks..Oh and the belt is totally shreaded might I add.
So I take the two bottom bolts that hold that cover on, and the pulley and washers fall out. I had to tap on the screw head to get it out. I've added photos, but that bolt snapped within the output drive shaft. I'm at a loss on how this could happen - any thoughts out there?
Anyway, that bolt is part number 10200241 and holds pulley part 35000111 which is the pulley to the output shaft which is 35600050 - in case anyone is curious on where this is at. At this point, has 38k miles, I doubt Harley is going to help me. I'm considering reaching out to them but I have little faith, seeing as it took years to acknowledge the brake issues. Which might I add, I'm on my third set of calipers.
Since I've never pulled that pulley out before, I'm not sure what the threads are supposed to be like in the output shaft. I'm sure I can use a bolt extractor to get it out, but how much threading is supposed to hold this bolt in? does it go from the end of the shaft, all the way down? I don't feel threads in the section where the bolt is missing. Or is that shaft ruined and need to be replaced, which is the worst case scenario.. that's a lot of work from what I can see right now.
Any help or input would be great.
Well I pull over and see what looks like a bolt sticking through the belt cover. My Heart sinks..Oh and the belt is totally shreaded might I add.
So I take the two bottom bolts that hold that cover on, and the pulley and washers fall out. I had to tap on the screw head to get it out. I've added photos, but that bolt snapped within the output drive shaft. I'm at a loss on how this could happen - any thoughts out there?
Anyway, that bolt is part number 10200241 and holds pulley part 35000111 which is the pulley to the output shaft which is 35600050 - in case anyone is curious on where this is at. At this point, has 38k miles, I doubt Harley is going to help me. I'm considering reaching out to them but I have little faith, seeing as it took years to acknowledge the brake issues. Which might I add, I'm on my third set of calipers.
Since I've never pulled that pulley out before, I'm not sure what the threads are supposed to be like in the output shaft. I'm sure I can use a bolt extractor to get it out, but how much threading is supposed to hold this bolt in? does it go from the end of the shaft, all the way down? I don't feel threads in the section where the bolt is missing. Or is that shaft ruined and need to be replaced, which is the worst case scenario.. that's a lot of work from what I can see right now.
Any help or input would be great.