Harley Davidson Street Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
81 Posts
Discussion Starter · #1 · (Edited)
I looked under the frame to find some threads and where the center stand would bolt into. I didn't see any. Does anyone know where the stand bolts into?
Here's a nice explanation on attaching the stand, but no pix.

At 5:45 in this video the voice says, 'there's a hole right here'. But, the image is almost useless. I can't see a hole.

 

·
Registered
Joined
·
81 Posts
Discussion Starter · #2 ·
I finally got the center stand bolted on. It was awkward for me. If I had to do it over again, I wouldn't. I'd have the dealer take over. Happydaze had a helpful post. Near the end of his post he explained how to get the stand secure. Very helpful.

The stand will make it easy to check and fill tire pressure. The next project will be, using the center stand, install the Gerbings heat controllers.
  • Get both bolts snug
  • Put the bike on the center stand. The diameter of the holes is bigger than that of the bolts. Putting the bike on the stand will push the stand up all the way.
  • Final tighten both bolts.

 
1 - 2 of 2 Posts
Top