Harley Davidson Street Forums banner
1 - 2 of 2 Posts

· Registered
Joined
·
183 Posts
Discussion Starter · #1 ·
I had already installed the rear rack on the mounts. The first thing I needed to do was to loosen the bolts and remove the rear rack. Next, take out the bar mount plate by removing and replacing all the mount bolts. Next, hold the saree guard while re-attaching the hardware. Do the other side. Tighten up and you're done.
I'll put up the part numbers on the guards if anyone is interested.
Now the saddle bags are hanging easier. With the guards on, any throw over saddle bags will work on a Street. Automotive lighting Motor vehicle Hood Automotive tire Automotive design
Tire Wheel Hood Automotive lighting Blue
 

· Super Moderator
2016 Harley-Davidson Street 750 in Sunglo Velocity Red
Joined
·
932 Posts
That's the route I took. Be sure to save the metal plates you take out from under the rear fender bracket in case you ever want to take the guards off.
 
  • Helpful
Reactions: Lesblank
1 - 2 of 2 Posts
Top